— 12 —
Using the USB Cable
The USB cable to connect the unit directly to a computer.
• See "Required System Configuration" on page 5 for the computer system that is required for direct
USB connection.
• The illustration below is just one possible connection configuration. The location and layout of USB
ports vary from computer to computer. See the documentation that comes with connected computer
for full details on connecting cables to it.
• Make sure ActiveSync installed on connected computer in order to exchange data with the unit over
a USB connection. See the
ActiveSync Help
for details about setting up and using ActiveSync.
To connect to a computer using the USB cable
Before connecting the unit to a computer, make sure to first install the ActiveSync on connected computer. Use
the steps below to connect the unit to connected computer when prompted to do so during the software
installation procedure.
1. Plug the USB cable into the USB port of your computer.
2. Turn off the unit.
3. Connect the other end of the USB cable to the unit.
USB port
USB cable
• To disconnect the USB cable, squeeze in on the buttons on either side of the plug to unlock it, and then pull.
To Next Page
Loading...
