English
Saving Keyboard Setups to Registration Memory
E-45
1.
Press
bs
.
2.
Configure the tone, rhythm, and other settings
you can to include in the setup.
3.
Press
cm
to select the bank you want.
Each press of
cm
cycles through the bank numbers.
• You also can select a bank by holding down
cm
as you
use the
cl
(10-key) number buttons to enter a bank
number.
4.
While holding down
cr
, press a button from
cn
to
cq
to select an area.
This will save the settings you configured in step 2 into the
applicable setup.
• If there is anything already stored in the setup, it will be
replaced (deleted) by the new setup.
1.
Press
cm
to select the bank that contains the
setup you want to recall.
2.
Use buttons
cn
to
cq
to select the area whose
setup you want to recall.
This will recall the registration memory setup and
automatically configure the piano settings accordingly.
• Notes currently being sounded by the keyboard may stop if
you recall a setup that causes a change in octave shift
(page E-15). To keep this from happening, either select a
setup that does not cause a change in the octave shift
setting, or hold down the pedal (which will cause notes
currently being played to be sustained).
■ Saving registration Data on an External Device
• SD memory card (page E-58)
• Computer (page E-65)
■ Maintaining Data in Registration Memory
After you save data in registration memory, it will remain there
as long as power is supplied to the piano. However, if you
disconnect the AC adaptor, data in registration memory will be
deleted.
To save a setup to registration
memory
Lights
Bank number
Bank 4
Store
Stored in Setup 4-1
To recall a setup from registration
memory
Bank 6
Recal l
Setup 6-1 recalled
CDP200R_e.book 45 ページ ２００８年４月２１日 月曜日 午後３時４分
To Next Page
Loading...
