Recording Your Keyboard Play
E-48
3.
Press a button from
cn
to
cr
to select the track
number of the next track to which you want to
record.
This will enter record standby for the track you selected.
Example: Track 2
• If you want to use a different tone than the one you
used in Track 1, press
bt
and then use
cl
(10-key) to
input the tone number.
4.
Press
bo
.
This will start playback of what you recorded up to this
point in other tracks and record what you play on the
keyboard to the currently selected track. Play the notes
you want on the keyboard.
5.
To stop recording, press
bo
.
• To play back what you have recorded, press
bo
again.
Each press of
bo
starts and stops playback.
6.
Repeat steps 2 through 5 to record the other
tracks.
7.
After you finish recording all of the tracks,
press
bo
.
• This will start playback of the recorded tracks. Press
bo
to stop or restart playback.
• At this time you can turn off playback of specific tracks
using buttons
cm
to
cr
. Pressing a key toggles playback
of each track on (track number displayed) or off (track
number not displayed).
• If you want to re-record a track, press
8
. This will
return to step 2 of the above procedure. Only the tracks
that are turned on (displayed) above will play as you
re-record.
Example: Tracks 2 and 3 selected
8.
Press
8
twice to exit the recorder mode.
■ To delete a recorded track
In step 3 of the above procedure, do hold down
8
(without
pressing any keyboard key) until the message “Tr.Del?”
appears on the display. Press [+] (YES) to delete the track, or
[–] (NO) to cancel the delete operation.
You can record up to five songs (numbered 1 through 5) in
memory. After that, you can select a specific song for
playback.
1.
Press
bs
.
2.
Press
8
.
A song number will appear in the upper left corner of the
display for a few seconds. While it is, use
cl
(10-key) to
specify the number of the song you want to record or play
back. The song number will disappear if you do not
perform any operation.
Example: Track 2
3.
Press
8
to record, or
bo
to play back.
To stop recording or playback, press
bo
.
4.
Press
8
twice to exit the recorder mode.
■ To delete recorded data
In step 2 of the above procedure, do hold down
8
(without
pressing any keyboard key) until the message “Song Del?”
appears on the display. Press [+] (YES) to delete the song, or
[–] (NO) to cancel the delete operation.
Flashes
Flashes
Recorded track number flashes on the display
Disappears
Recording Two or More Songs,
and Selecting One for Playback
Disappears
P l a
y
N o .
CDP200R_e.book 48 ページ ２００８年４月２１日 月曜日 午後３時４分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
