25
Quick Start Basics
IMPORTANT!
• Take care to ensure that your fingers are not blocking or
are not too close to the flash. Fingers can cause unwanted
shadows when using the flash.
The following procedure describes how to shoot a single snapshot. For information
about shooting a series of shots (Continuous Shutter), see page 49.
1. Press [r] (REC) to turn on the camera.
2. Set the mode dial to t (Auto).
3. Point the camera
at the subject.
• You can zoom the
image, if you want.
To shoot a snapshot
Auto icon
Remaining snapshot memory
capacity (page 194)
Shutter button
Mode dial
[r] (REC)
Monitor screen
w Wide Angle z Telephoto
Zoom controller
To Next Page
Loading...
Need help?
General
