GETTING READY
25
Power Requirements
Your camera is powered by a rechargeable lithium ion
battery (NP-20).
To load the battery
1.
Pressing the battery cover on the side of the
camera, slide it in the direction indicated by
the # mark and then swing it open.
2.
Align the arrow mark on the battery with the
arrow mark on the camera as shown in the
illustration, and slide the battery into the
battery compartment.
3.
Swing the battery cover closed, and then slide
it in the direction indicated by the arrow while
pressing down on it.
IMPORTANT!
• Use only the special NP-20 rechargeable lithium ion
battery to power this camera. Use of any other type
of battery is not supported.
NOTE
• To remove the battery, open the battery cover.
Taking care that the battery does not suddenly fall
out of the camera, tilt the camera towards the side.
When the battery slides out part way, pull it out by
hand.
The battery is not charged when you purchase the
camera. You need to charge the battery before using
the camera for the first time (page 26).
NP-20
Arrow marks
To Next Page
Loading...
Need help?
General
