67
OTHER RECORDING FUNCTIONS
NOTE
• The initial default setting is “REC Mode”.
When you want to assign this function to
[$] and [#] keys:
Recording mode
•[$] and [#] cycle through recording
modes: Snapshot, Best Shot, Movie
(page 142).
Flash mode
•[$] and [#] cycle through the flash
mode settings (page 45).
EV shift
•[$] decreases compensation, [#]
increases compensation (page 51).
White balance setting
•[$] and [#] cycle through white
balance settings (page 52).
ISO sensitivity
•[$] and [#] cycle through sensitivity
settings (page 65).
No function assigned
Select this:
REC Mode
Flash
EV Shift
White Balance
ISO
Off
Assigning Functions to the [!] and ["]
Keys
A “key customization” feature lets you configure the [!]
and ["] keys so they change camera settings whenever
they are pressed in the REC mode. After you configure the
[!] and ["] keys, you can change the setting assigned to
them without going through the menu screen.
1.
In the REC mode, press [MENU].
2.
Select the “REC” tab, select “U/D Key”, and
then press [#].
3.
Use [!] and ["] to select the setting you
want, and then press [SET].
To Next Page
Loading...
Need help?
General
