45
BASIC IMAGE RECORDING
5.
Record the image.
IMPORTANT!
• The flash unit of this camera fires a number of times
when you record an image. The initial flashes are
pre-flashes, which the camera uses to obtain
information it uses for exposure settings. The final
flash is for recording. Make sure that you keep the
camera still until the shutter releases.
• Image recording may not be performed if you press
the shutter release button while the operation/flash
charge lamp is flashing amber.
NOTE
• You can use the key customization feature (pages
66, 67) to configure the camera so the flash mode
changes whenever you press [!] and ["], or [#] and
[$] while in the REC mode.
Using the Flash
Perform the following steps to select the flash mode you
want to use.
1.
In the REC mode, press [MENU].
2.
Use [!] and ["] to select the “REC” tab.
3.
Use [#] and [$] to select “Flash”, and then
press ["].
4.
Use [#] and [$] to select the flash mode you
want, and then press [SET].
To do this:
Have the flash fire automatically
when required (Auto Flash)
Turn off the flash (Flash Off)
Always fire the flash (Flash On)
Fire a pre-flash followed by image
recording with flash, reducing the
chance of red-eye in the image (Red-
eye reduction). Have the flash fire
automatically when required.
Select this setting:
Auto
To Next Page
Loading...
Need help?
General
