PLAYBACK
148
Displaying Camera Images on a TV Screen
You can display recorded images on a TV screen and even
use a TV screen to compose images before you record
them. To display camera images on a TV, you need a
television equipped with a video input terminal.
1.
Connect one end of the AV cable that comes
with the camera to the camera’s USB/AV
connector, and the other end to the video
input terminal of the TV.
IMPORTANT!
• Audio volume can be adjusted only when playback is
being performed or is paused.
• If your recording has index marks (page 108) inside
it, you can jump to the index mark before or after the
current playback location by pausing playback and
then pressing [왗] or [왘]. Next, press [SET] to
resume playback from the index mark position (page
108).
To do this:
Fast forward or fast reverse
the audio
Pause and unpause audio
playback
Adjust audio volume
Toggle monitor screen
indicators on and off
Cancel playback
Do this:
Hold down [왗] or [왘].
Press [SET].
Press [왔] and then use [왖]
and [왔].
Press [왖] (DISP).
Press [MENU].
Ye l l o w
(Video)
White
(Audio)
AV cable
USB/AV connector
Video input
terminal
TV
Make sure that the side of the connector that is marked
with an arrow (
왖
) is facing in the same direction as the
front (lens side) of the camera.
To Next Page
Loading...
Need help?
General
