APPENDIX
240
Using the USB Cradle to Print Images
You can place the camera onto the USB cradle and
connect the cradle to a printer to print images.
1.
Connect the USB cable that comes bundled
with the camera to the USB cradle and a
printer.
USB port
Connector A
USB cable
Connector B
[ ] (USB port)
• Also, connect the AC adaptor to the USB cradle and
plug the AC adaptor into an electrical outlet.
• If you are using battery power without the AC
adaptor, make sure that the battery is fully charged.
2.
Turn off the camera, and then set the camera
on the USB cradle.
3.
Turn on the printer and then perform the
procedure in the camera user’s guide to print.
4.
After you are finished printing, press the USB
cradle’s [USB] button, and then turn off the
camera.
IMPORTANT!
• Never disconnect the USB cable, or perform any
camera or USB cradle operation while printing is in
progress. Doing so causes a printer error.
To Next Page
Loading...
