VIEWING IMAGES ON A COMPUTER
197
IMPORTANT!
• If you plan to transfer file data from the camera’s
built-in memory to your Macintosh, make sure there
is no memory card loaded in the camera. If there is,
remove the memory card from the camera before
you connect to your Macintosh.
■ Establish a connection between the camera
and your Macintosh
1.
Make sure the camera’s battery is fully
charged.
2.
Turn on the camera, and then press [MENU].
• It makes no difference whether the camera is in a
REC mode or the PLAY mode.
3.
Select the “Set Up” tab, select “USB”, and
then press [왘].
4.
Use [왖] and [왔] to select “Mass Storage”, and
then press [SET].
To Next Page
Loading...
Need help?
General
