33
INTRODUCTION
■ Data Error Precautions
• Your digital camera is manufactured using precision digital
components. Any of the following creates the risk of
corruption of data in camera memory.
–Removing the battery or memory card from the camera
while the camera is performing an operation
–Removing the memory card from the camera while the
operation lamp is flashing green after turning off the
camera
– Disconnecting the USB cable while a data communication
operation is being performed
– Using a battery that is low
– Other abnormal operations
Any of the above conditions can cause an error message to
appear on the monitor screen (page 257). Perform the action
indicated by the message that appears.
■ Operating Environment
• The operating temperature range of the camera is 0°C to
40°C (32°F to 104°F).
• Do not place the camera in any of the following locations.
– In an area exposed to direct sunlight, or large amounts of
moisture or dust
– Near an air conditioner or in other areas subjected to
extreme temperature or humidity
– Inside of a motor vehicle on a hot day, or in an area
subjected to strong vibration
To Next Page
Loading...
Need help?
General
