75
SHOOTING A SNAPSHOT
1. In the REC mode, press [MENU].
2. On the “Quality” tab, select “Flash Assist” and
then press [X].
3. Use [S] and [T] to select “Off” and then press
[SET].
When you want to use flash assist, select “Auto” here.
IMPORTANT!
• Flash assist may not produce the desired result for some
types of subjects.
• Any of the following can result in the flash assist effect
being canceled out.
– Changing the flash intensity (page 74)
– Correcting brightness (EV shift) (page 125)
– Changing ISO sensitivity (page 129)
– Changing the contrast setting (page 134)
■ Flash Precautions
• The desired effect may not be obtained when the subject is
too far away or too close.
• Flash charging time depends on operating conditions (battery
condition, ambient temperature, etc.) With a fully charged
battery, it takes anywhere from a few seconds to 7 seconds.
• Shooting with flash turned off when lighting is dim results in a
slow shutter speed, which can cause image blur due to hand
movement. Secure the camera with a tripod, etc.
• With red eye reduction, the flash is fired automatically in
accordance with exposure. It does not fire in areas where
lighting is bright.
• The presence of outdoor sunlight, fluorescent lighting, or
some other light source can cause abnormal image colors.
To Next Page
Loading...
Need help?
General
