107
(3) TCP/IP settings
Item Content Default
DHCP Specify “Enable” or “Disable” for DHCP. DHCP
IP address
*1
Set the IP address.
Subnet mask
*1
Set subnet mask.
Default gateway
*1
Set the default gateway.
DNS1 Set primary DNS server address.
DNS2 Set secondary DNS server address.
WINS1 Set primary WINS server address.
WINS2 Set secondary WINS server address.
*1 This can be specified if DHCP is disabled.
(4) Setting storage
The storage locations for wireless LAN settings are as follows.
Storage location
Item Content When
shipped
Reset Full
reset
User
disk
clear
INI file This file is created when the Casio
wireless LAN setting tool is used for
setup
None Settings
retained
Settings
retained
When
shipped
Registry These are settings for the operation
of the wireless LAN drivers and
supplicants. This registry is set with
the MS standard tool or the Casio
wireless LAN setting tool
Default
settings
only
Settings
retained
When
shipped
*2
When
shipped
E2PROM This is used for settings which must
be retained even through a user
disk clear, such as custom
country-specific settings.
None Settings
retained
Settings
retained
Settings
retained
*2 The registry reverts to shipped defaults, but on startup the settings are re-configured from the
INI file, so effectively the settings are retained.
Backup/restore
Item Own
terminal
Other
terminal
INI file Yes Yes
Registry Yes
No
*
３
E2PROM Yes Yes
*3 The registry itself is copied, but the wireless LAN setting information is encrypted uniquely for
each terminal, so the information cannot be read. Therefore, information set with standard MS
configuration cannot be copied.
To Next Page
Loading...
Need help?
General