111
3. Introduction
3.1 Perform Initial Setup
3.1.1 Startup screen
(1) Initial screen
After the terminal first boots, the following Startup screen will appear. The following settings can be
made from here:
Touch panel calibration
(2) Desktop screen
The following Desktop screen appears after Initial Setup is complete.
［Initial screen］(New start-up only) ［Home screen］
Execution operation Explanation
Tap the screen Changes to the Touch Screen Position Calibration screen. Finish
touching the five points, then Press the Enter key to save the setting
content.
(Refer to “3.2.1 Screen setting” for details)
[Remarks]
However, everything must be reset in the event of a full reset of the terminal.
To Next Page
Loading...
