225
［backup］screen example
Restore
The restore procedure is as follows:
3. 0Restore.exe starts automatically.
After a full reset of the unit, the Welcome screen is displayed, then approximately 10s
later, ”¥FlashDisk¥CE¥ARM¥restore.exe“ starts automatically.
* The Welcome screen closes automatically.
4. Set date/time
A screen for setting date and time will automatically appear. Set the correct date and time.
5. Run restore
Restore from the backed up data runs automatically.
6. Unit reset
The unit automatically resets approximately 5s after the restore process is complete.
Execution logs
The auto restore execution log is saved in “¥FlashDisk¥CE¥ARM¥Restore.log”.
[Remarks]
i A maximum of 30 logs combined are stored for backup and restore operations.
ii If the log file exceeds over 30 logs, records will be deleted, starting from the oldest.
Skipping restores
When the auto restoration is about to take place, pressing the 5 key on the terminal will output a
warning sound and skips the imminent restoration process.
Execution error conditions
The following are the conditions under which an execution error occurs.
Backup or restoration takes place when the battery pack capacity is low.
The backup takes place when the FlashDisk has insufficient capacity.
The backup or restoration takes place when the memory has insufficient capacity.
To Next Page
Loading...
Need help?
General