13
Getting Started
To load 2-ply paper for printing of receipts
7.
Install receipt/journal paper (continued…)
Follow steps
11
11
1 through
55
55
5 under "T o load 1-ply paper for printing of receipts" above.
Pass paper over silver plate.
66
66
6
Separate the two sheets of
the paper. Pass the outer
sheet under the separator.
00
00
0
Insert the leading end of the inner sheet (which will be
your journal) into the take-up reel, as described starting
from step
22
22
2 under "T o load 1-ply paper for printing of a
journal."
AA
AA
A
Replace the printer cover, passing the leading end of the
outer sheet through the cutter slot. Tear off the excess pa-
per.
99
99
9
Press the f key until about
20 cm or 30 cm of paper is
fed from the printer.
77
77
7
Pass the inner sheet over the
separator.
88
88
8
Join the ends of the paper
again and insert them into the
paper inlet.
To Next Page
Loading...
