Casio PCR-360 - Programming Compulsory and Clerk Control Function

57
Convenient Operations and Setups
Programming compulsory and clerk control function
About compulsory, clerk control function…
The following procedure lets you program a number of functions.
• Use o key as "Clerk" key/"Open" key.
*1
• Assign "00"key/Assign "000" key.
• Reset/Not reset (to 0001) the consecutive number when the Daily RESET report is issued.
• Required/Not required to input the cash in drawer amount before the daily READ/RESET report.
(MONEY DECLARATION)
• Prohibit/Allow the cancel operation.
• Force S key operation before finalization.
• Clear the key buffer when the transaction is terminated.
• Display Hour/Minute/Second or Hour/Minute on time display.
*1
Effective only after all RESET reports are issued.
Programming procedure default
X
Z
CAL
REG
OFF
RF
PGM
PGM
A-A08
Mode Switch
6 £S 6 º§™™S 6 :::: 6C6S
———————————————————————————————————————————————————
Open = 0
Use "Clerk"function/Use "Open" function a
Clerk = 1
——————————————————————————————————————————————
"00" = 0
Assign "00" key/Assign "000" key b
"000" = 4
———————————————————————————————————————————————————
Reset = 0
Reset/Not reset the consecutive number c
Non reset = 2
————————————————————————————————————————
Allow = 0
Prohibit/Allow the cancel operation. d
Prohibit = 4
——————————————————————————————————————————————
No = 0
Force S key operation before a finalization e
Compulsory = 2
——————————————————————————————————
Required/Not required to input the cash in drawer Not required = 0
f
amount before the Daily report Required = 4
————————————————————————————————————————
Clear the key buffer when the Not clear = 0
g
transaction is terminated Clear = 1
—————————————————————————————
Suppress = 0
Display "seconds" during time display. h
Display = 4
——————————————————————————————————
:
(g+h)
:
(e+f)
:
(c+d)
:
(a+b)