Casio PhoneMate TA-150 - Check Programmed Times for Timer Greeting Mode

PAGE
1111
1111
11
3
Press GREETING TIME SET . The
TA-150 will announce the time for
GREETING 2.
NOTES:
ν The TIMER-SELECT MODE can only set to the hour.
Minutes cannot be programmed in this mode.
ν GREETING 2 must always be set to a later time than
GREETING 1. If both GREETING 1 and GREETING 2
are set to the same time, or GREETING 1 is later than
GREETING 2, an error tone will be heard and the unit will
revert to the last properly programmed and sequenced
times for GREETING 1 and GREETING 2.
ν Failure to record both greetings prior to setting this
mode, may possibly result in callers hearing the pre-
programmed greeting, “ Please record a message after
the tone. ” Greetings cannot be recorded while in the
TIMER-SELECT MODE. If you try to record a greeting,
by pressing GREETING RECORD while in this mode,
the machine will rapidly beep three times.
5:00 p.m.
CHECK PROGRAMMED
TIMES FOR TIMER
GREETING MODE
To review the times programmed in the TIMER
GREETING MODE:
1
Press GREETING TIME SET .
(Under the lid.) The display will show the
activation time for GREETING 1. For
example, “8:00 AM” will appear and you
will hear:
CONV RECORD
MEMO RECORD
SKIP
REPEAT
MESSAGE FILE
SLOW
_
FAST
+
PLAY/
PAUSE
PREVIEW NEW
ALL
12:30
PM
SET CHECK
CODE SET CODE CHECKTIME
RECORD CHECK SELECT TIME SET
ANNOUNCE ONLY ON/OFF
GREETING
GREETING 1 2
RECORD CHECK SELECT TIME SET
GREETING
GREETING 1
8:00
AM
Enter the time
for greeting one.
GREETING 2
5:00
PM
2
Press GREETING TIME SET again
and the TA-150 will announce the
activation time for GREETING 1. The
LCD clock will then display the time set
for GREETING 2.
8:00 a.m.
Enter the time for
greeting two.