R-37
QT-6600 Reference Manual
84) Round repeat key (Function code 116)
This key is used to register the same items which were ordered just before.
Programmability: Refer to page 112 of the programming manual.
85) Open check key (Function code 117)
This key is used to issue an open check report of an assigned clerk.
Programmability: Refer to page 109 of the programming manual.
86) Media change key (Function code 118)
This key is used to change media in drawer amounts. Pressing this key enters media change
operation.
87) Seat number key (Function code 119)
This key is used to enter and print seat number.
88) Eat-in key (Function code 128)
This key is used to specify if the customer eats in the restaurant. Before closing a
transaction, press this key.
Programmability: Refer to page 111 of the programming manual.
89) Takeout key (Function code 129)
This key is used to specify if the customer takes out items. Before closing a transaction,
press this key for the tax exemption.
Programmability: Refer to page 111 of the programming manual.
90) Store key (Function code 130)
This key is used for storing the check number of the registered items. Allocate this key to
the terminal at the drive-through entrance. When this key is pressed, registered item data
will be stored, and then these data will transfer to the youngest check number.
Programmability: Refer to page 111 of the programming manual.
91) Recall key (Function code 131)
This key is used for recalling the transferred check number by the store key. When you
press this key, the check number will appear in order of the oldest record.
Programmability: Refer to page 113 of the programming manual.
92) Subdepartment key (Function code 133)
This key is used to register items for the subdepartment.
Programmability: Refer to page 90 of the programming manual.
93) Subdepartment number key (Function code 134)
This key is used to enter subdepartment numbers.
94) Department number key (Function code 135)
This key is used to enter department numbers.
95) List key (Function code 136)
This key is used to display menu lists.
Programmability: Refer to page 109 of the programming manual.
96) List number key (Function code 137)
This key is used to designate list number.
97) Number look up key (Function code 138)
This key is used to register a scanning PLU item whose scanning code is set to this key.
98) Split payment (Dutch account) key (Function code 140)
This key is used to share the total payment by customer.
Programmability: Refer to page 113 of the programming manual.
99) Not found PLU key (Function code 142)
This key is used to declare an item which has not been set in the scanning PLU file yet as
not found PLU item. After occuring “Error 028”, press this key and perform linked
department registration.
To Next Page
Loading...
Need help?
General
