R-38
Application System
100)Customer number key (Function code 148)
This key is used to enter customer ID number.
Programmability: Refer to page 115 of the programming manual.
101)Payment key (Function code 149)
This key is used to declare the following transactions as payment.
102)Swipe key (Function code 172)
This key is used to enter before swiping a magnetic card/ scanning a barcode.
Programmability: Refer to page 116 of the programming manual.
103)Electronic journal display key (Function code 207)
This key is used to display the stored journal.
104)Display mode key (Function code 219)
This key is used to change display modes (normal mode/item consolidation mode).
105)Cancel key (Function code 236)
Invalidates all preceding data registered for departments, PLUs and set menus within a
transaction. This key must be pressed before the transaction involving the data to be
invalidated is finalized. It is also effective even after calculation of subtotal amount.
Programmability: Refer to page 109 of the programming manual.
106)Worktime key (Function code 237)
This key is used to clock-in/ out in simple time and attendance operation.
Programmability: Refer to page 116 of the programming manual.
107)Item search key (Function code 246)
Use this key to search an item by its name.
Programmability: Refer to page 114 of the programming manual.
108)Order character change key (Function code 252)
This key is used to change the order character. The order characters not only of the item
but in the order character table can be printed.
Programmability: Refer to page 114 of the programming manual.
109)Function list key (Function code 219)
This key is used to display function list. After displaying a function list, you can input the
keys in the list.
Programmability: Refer to page 117 of the programming manual.
110)Location change key (Function code 260)
Use this key to select the pop-up window which shows the table layout of each floor/part
of the restaurant.
Programmability: Refer to page 114 of the programming manual.
111)Table sharing key (Function code 261)
Use this key to assign one table to two or more customer groups.
To Next Page
Loading...
Need help?
General
