BASIC IMAGE RECORDING
E-61
Using the Infinity Mode
The Infinity Mode sets the focus near infinity. It is a good
choice for scenery and other far-off subjects. Focus adjust-
ment starts automatically whenever you press the shutter
release button about half way down.
1.
Press / /MF RESIZE to cycle through the fo-
cus mode settings until the indicator ap-
pears on the display. This indicates the Infinity
Mode.
2.
Compose the image and record it.
• See “Using the Auto Focus Mode” on page E-59 for
information about how the camera focuses an image
automatically.
• You can check the current status by looking at the op-
eration lamp and focus frame. See “Using the Auto
Focus Mode” on page E-59 for more information.
Using the Manual Focus Mode
With Manual Focus, you make the required focus settings by
hand. The following shows the relationship between the opti-
cal zoom factor and the focusing distance for the Manual
Focus Mode.
1.
Press / /MF RESIZE to cycle through the fo-
cus mode settings until the indicator ap-
pears flashing on the display. This indicates
the Manual Focus Mode.
2.
While the indicator is flashing, use [왔] and
[왖] to focus the image.
• If you do not perform any focus operation for about
three seconds, the indicator stops flashing.
• You can press / /MF RESIZE while the indica-
tor is on the monitor screen to change to another focus
mode, if you want.
Optical Zoom Factor
1X
3X
Focusing Distance
6cm to ∞
18cm to ∞
To Next Page
Loading...
Need help?
General
