BASIC IMAGE RECORDING
E-63
4.
Press the shutter release button the rest of the
way down to record the image.
NOTE
• Locking the focus also locks the exposure setting.
Specifying the Focus Frame Location
Normally, the Auto Focus frame is located in the center of
the screen. Use the following procedure when you need to
change the location of the focus frame.
NOTE
• Instead of moving the focus frame, you could also use
the procedure under “Using Focus Lock” on page E-
62 to lock the focus on one subject and then move the
camera so the focus frame is pointed at another sub-
ject.
1.
Align the POWER/Function Switch with REC.
2.
Compose the image you want to record.
3.
Holding down SHIFT to display all of the avail-
able Auto Focus frame positions, use [왘], [왗],
[왔], and [왖 ] to move the [+] mark to the focus
frame location you want to use.
• The currently selected Auto Focus frame is the one
where the [+] mark is located.
4.
After selecting the focus frame you want to
use, release SHIFT and then press the shutter
release button about half way to perform auto
focus.
• This causes the focus frame you selected to change
green when proper focus is achieved (or red if there is
a problem with the focus).
5.
Press the shutter release button the rest of the
way to record the image.
To Next Page
Loading...
Need help?
General
