29 Operation
Once detected, the selected source information will appear at the corner of the screen for
seconds. If there is multiple equipment connected to the projector, repeat steps 1-2 to
search for another signal.
Shutting down the projector
1. Press and a confirmation message will appear
prompting you. If you don't respond in a few
seconds, the message will disappear.
2. Press a second time.
3. The power indicator becomes a steady red and fans
stop. Disconnect the power cord from the power
outlet.
• The brightness level of the projected image will change accordingly when you switch between different
input signals.
• For best display picture results, you should select and use an input signal which outputs at the
projector’s native resolution. Any other resolutions will be scaled by the projector depending upon the
“aspect ratio” setting, which may cause some image distortion or loss of picture clarity. See "Aspect
Ratio" on page 33.
The indicator lights may stay lit even after you unplug the power cord. However, this is not a malfunction.
To Next Page
Loading...
Need help?
General
