38 Controlling the projector remotely
Controlling the projector remotely
Once you have the correct IP address for the projector and the projector is on or in standby
mode, you can use any computer that is on the same local area network to control the
projector.
1. Enter the address of the projector in the address bar of your browser and press Enter.
2. The Crestron (eControl) page displays the Crestron eControl user interface. The eControl
page provides a variety of virtual keys to control the projector or adjust the projected
pictures.
• Main page
i. These buttons function the same as the ones on the OSD menus, projector or remote
control. See "Projector & Remote control" on page 16 and "Menu operation" on page 30
for details. However, if you intend to go back to previous OSD menu, exit and save menu
settings, press MENU.
ii. To switch input source, click your desired signal.
The screenshots in this user’s guide are for reference only, and may differ from the actual design.
To Next Page
Loading...
Need help?
General
