Casio XJ-L8300HN - Pjlink Commands

40 Controlling the projector remotely
PJLink Commands
This projector supports standard protocol PJLink for projector control. Supported commands
are as below.
Command Control details Notes
POWR Power supply control
Parameters
0 = Standby
1 = Power ON
POWR ?
Power supply status
query
Parameters
0 = Standby 1 = Power ON
INST ?
Input selection index
query
No.1 11
No.2 31
No.3 32
No.4 51
INPT Input selection
Parameters
11: RGB 1
31: HDMI 1
INPT ? Input selection query
32: HDMI 2
51: HDBaseT
AVMT AV MUTE control
Parameters
VIDEO & AUDIO MUTE mode off
AVMT ? AV MUTE status query VIDEO & AUDIO MUTE mode on
ERST ? Error status query
Parameters
1st byte: Indicates fan errors, range 0 , 2
2nd byte: Indicates light source errors, range 0 , 2
3rd byte: Indicates temperature errors, range 0 , 2
4th byte: Fixed at 0
Definitions for each value from 0 or 2 are as follows.
0 = No error known 1 = Warning 2 = Error
LAMP ? Light source status query
Parameters
1st digits (1 – 5 digits) : Light source cumulative
operating time
NAME ? Projector name query “C
ASIO” is returned.
INF1 ? Manufacturer name query “C
ASIO” is returned.
INF2 ? Model name query "XJ-L8300HN" is returned.
INFO ?
Other information query
"" (null) is returned.
CLSS ? Class information query “1” is returned.
For details, visit the CASIO website at the URL below.
http://world.casio.com/download/projector/