36 Menu operation
INFORMATION menu
Serial Port
Setting
Allows you to select a preferred control port: through the RS-232C port
(SERIAL port on the projector) or the HDBaseT port (HDBaseT input port on
the projector).
Network
Settings
This projector is equipped with network function. You can manage and
control the projector from a remote computer using a web browser when they
are properly connected to the same local area network.
• Wired LAN
• Status: Shows the connection status.
• DHCP: Select On if you are in a DHCP environment and IP Address,
Subnet Mask, Default Gateway, DNS Server settings will be
automatically retrieved. Select Off if you are in a non-DHCP
environment and make adjustments to below settings.
For details on controlling the projector from a remote computer, see "Controlling the
projector remotely" on page 38
.
• AMX Device Discovery: When this function is On, the projector can be
detected by AMX controller.
• MAC Address: Displays the mac address for this projector.
Network
Standby
• Enable Network Standby Mode: Allows the projector to provide the
network function in standby mode.
• Auto Disable Network Standby Mode: Allows the projector to disable the
network function after a set period of time after it enters standby mode. For
instance, if 20 min is selected, the projector is able to provide the network
function for 20 minutes after it enters standby mode. When 20 minutes is
up, the projector enters normal standby mode.
Reset All
Settings
Returns all settings to the factory preset values.
The following settings will still remain: Picture Mode, User Mode Settings, Brightness,
Contrast, Color, Tint, Sharpness, Advanced, Aspect Ratio, Projector Mode, Rename
Input, Audio Out Volume, Mute, Password, Serial Port Setting, Network Settings and
Network Standby.
Input Shows the current signal source.
Picture Mode Shows the selected mode in the PICTURE menu.
Resolution Shows the native resolution of the input signal.
Color System Shows input system format.
• IP Address
Only available when DHCP is set to Off. Use /
to select a column and use / to adjust the
value.
• Subnet Mask
• Default Gateway
• DNS Server
• Apply Enacts these settings.
To Next Page
Loading...
Need help?
General
