11
Projector operations are performed using the remote controller that comes with it. Point the remote
controller signal emitter at one of the signal receivers on the projector as you perform remote
controller key operations. The maximum range of the remote controller signal is approximately
5 meters (16.4 feet) (between signal emitter and receiver).
Important!
z To avoid running down the battery, store the remote control unit so its keys are not pressed
inadvertently.
Remote Controller
1 Remote control signal emitter
2 [P] (Power) key
Turns power on or off.
3 [INPUT] key
For changing the input source.
4 Keys for performing projection operations and for configuring
projector settings.
5 These keys are mainly used for File Viewer (page 25)
projection operations.
1
2
3
4
5
To Next Page
Loading...
