47
Operating the Projector
This section explains how to use the remote controller to perform projector operations.
To use manual keystone correction (KEYSTONE)
The projector has a keystone correction feature that prevents
distortion of the projected image when projecting from an
angle.
Use the [KEYSTONE +] and [KEYSTONE –] keys to adjust
keystone correction manually.
To zoom an image (D-ZOOM)
1.
Press the [D-ZOOM] key.
z This will enlarge the center of the projected image one step.
2.
To zoom in on the center of the projected image more, press the [D-ZOOM] key
again.
z Each press of [D-ZOOM] zooms in (increases the zoom factor). Holding down [D-ZOOM]
continuously scrolls the zoom factor.
3.
While an image is zoomed, use the [S], [T], [
W
], and [
X
] keys to scroll the view
to other parts of the image.
4.
To exit the zoom operation, press the [ESC] key.
To adjust the volume level (VOLUME)
1.
Press the [VOLUME +] or [VOLUME –] key.
z This causes the “Volume” screen to appear on the projected image.
2.
Press the [VOLUME +] key to increase the volume, or the [VOLUME –] key to
lower the volume.
3.
After the setting is the way you want, press the [ESC] key.
Output Image and Audio Operations
To Next Page
Loading...
Need help?
General
Weight and Dimensions
