59
Option Settings 2 3
Audio Out
Use this sub-menu to specify whether audio input from the input sources below
should be output to the speaker (Speaker*) or output to an external destination
(Line)*
1
.
z File Viewer (Movie playback audio)
z Network (Video stream projection movie audio)
z USB Display
z HDMI
*1 When Line is specified, the projector will output audio from its AUDIO OUT
terminal.
Option Settings 2 3
High Altitude
Turn the high-altitude fan speed setting on or off in accordance with the altitude of
the area where you are using the projector.
On: Select this setting when using the projector in a high altitude (1,500 to
3,000 meters / 5,000 to 10,000 feet above sea level) area where air is thin. This
setting increases cooling efficiency.
Off*: Select this setting at normal altitudes (up to 1,500 meters / 5,000 feet).
Important!
z Do not use this projector at altitudes greater than 3,000 meters (10,000 feet)
above sea level.
Option Settings 2 3
Control Panel Lock
Disable projector unit key operations.
See “Control Panel Lock” (page 65) for more information.
Option Settings 2 3
Standby RGB/Audio
Use this sub-menu to configure the projector for output of the video signal from the
COMPUTER IN 1 terminal to the MONITOR OUT terminal, and output of the audio
signal from the AUDIO IN 1 terminal and MIC terminal to the AUDIO OUT terminal
while the projector is in standby (projector off with power being supplied).
Output: Select this setting to output video and audio signals while the projector is in
standby.
No Output*: Select this setting not to output video and audio signals while the
projector is in standby.
Note
z When “Output” is selected for this setting, audio is output from the AUDIO
OUT terminal during standby, regardless of the projector’s current “Option
Settings 2 3 Audio Out” setting.
z Input signals from the COMPUTER IN 2 terminal and AUDIO IN 2 terminal
cannot be output from the MONITOR OUT terminal and AUDIO OUT
terminal during projector standby.
Option Settings 2 3
Closed Caption (V)
Use this sub-menu to specify whether to display closed captions when projecting a
video signal that includes them.
Off*: Closed captions not displayed.
CC1, CC2, CC3, CC4: Indicates the current closed caption output setting (CC1,
CC2, CC3, and CC4).
Note
z Keystone correction does not affect displayed closed caption text.
Option Settings 2 3
Timer Function
Display the timer function menu. For details, see “Using the Presentation Timer
(TIMER)” (page 52).
Option Settings 2 3
Microphone Input Level
Adjusts the volume level of audio input from the MIC terminal within the range of 0*
(mute) to 3 (maximum).
Option Settings 2 3
Restore Menu Defaults
Return all of the items in the “Option Settings 2” main menu to their initial defaults for
the currently projecting image source.
Multimedia Settings 3
Autorun
Specify whether to use (Enable*) or not use (Disable) the autorun function. For
details, see “Autorun” (page 32).
Use this menu item: To do this:
To Next Page
Loading...
