83
Command List
z Only the following functions are supported while the projector is turned off. Do not try to send any
other command to the projector.
z Input of a valid signal must be in progress in order to use a command to turn on blank screen or
change the aspect ratio.
R: Read enabled W: Write enabled
z Power on/off: Read
z Power on: Write
z Get light time: Read
Function
Command
Name
RW Setting Range
Power On/Off: PWR RW 0: Off, 1: On
Input Switching:
0: Switches the input source to the COMPUTER 1 terminal
and changes the COMPUTER 1 terminal setting to RGB.
1: Switches the input source to COMPUTER 1 terminal and
changes the COMPUTER 1 terminal setting to
component.
2: Switches the input source to Video.
3: Switches the input source to the COMPUTER 2 terminal
and changes the COMPUTER 2 terminal setting to RGB.
4: Switches the input source to COMPUTER 2 terminal and
changes the COMPUTER 2 terminal setting to
component.
6: Switches the input source to COMPUTER 1 terminal and
changes the COMPUTER 1 terminal setting to Auto.
7: Switches the input source to HDMI.
8: Switches the input source to Network.
9: Switches the input source to S-video.
10: Switches the input source to COMPUTER 2 terminal and
changes the COMPUTER 2 terminal setting to Auto.
11: Switches the input source to File Viewer.
12: Switches the input source to USB Display.
13: Switches the input source to CASIO USB Tool.
SRC RW 0: RGB1, 1: Component 1,
2: Video, 3: RGB2,
4: Component 2,
6: Auto1 (RGB/Component),
7: HDMI, 8: Network,
9: S-Video,
10: Auto2 (RGB/Component),
11: File Viewer,
12: USB Display,
13: CASIO USB Tool
Blank Screen: Switches the blank screen on or off. BLK RW 0: Off, 1: On
Volume: Specifies a value to adjust the volume level. This
setting is applied to the input source signal that is
currently being projected by the projector.
VOL RW 0 to 30
Color Mode: Selects the color mode. PST RW 1: Graphics, 2: Theater,
3: Standard, 4: Blackboard,
5: Natural
Aspect Ratio: Specifies the aspect ratio. ARZ RW 0: Normal, 1: 16:9,
2: 4:3, 3: Letter Box,
4: Full, 5: True, 6: 4:3 (Forced)
Get Light Time: Gets the light time from the projector. LMP R 0- Unit: Hours
Eco Mode: Enter Eco Mode. PMD RW 0: Off (Bright), 1: Off (Normal),
2: On (Auto), 3: On (Manual 1),
4: On (Manual 2),
5: On (Manual 3),
6: On (Manual 4),
7: On (Manual 5)
To Next Page
Loading...
