CBE 230 - Page 44

230 Series Auger Packer
44 OF 115
FEED SYSTEM ASSEMBLY
AUGER
 Check that the auger is centered in the spout. (See chapter on how to center filling spout)
 Check that the auger is not bent. Straighten or replace as required.
SPOUT
 Check for proper alignment of the spout and cone. Re-align as required using the load cell
and adjusting the flexure plates.
 Check the flexible seals for deterioration, bulging and/or cracking. R/R as required
 Remove any product build-up.
AUGER SEAL ASSEMBLY
PACKING
 Check stuffing box for leakage and adjust for proper compression. Adjust when box is
leaking.
 Check packing material for cleanliness. Replace as required.
AIR SEAL
 Check the shaft seals for deterioration and/or cracking and proper pressure on regulator.
Pressure on mini regulator should be 2-3 PSI. Adjust air pressure flow and if still leaking
replace seal.
INLET HOPPER ASSEMBLY
BEARINGS
 Check the bearing seals for deterioration and/or leaking grease. Grease or replace as
required.
 Check for excessive vibration with the agitator running. Replace as required.
HOPPER SEAL ASSEMBLY
PACKING
 Check for proper packing compression. If leaking, adjust compression or replace packing.
 Check packing material for cleanliness. Replace as required.
BAG CLAMP ASSEMBLY
PIVOTS
 Check for excessive wear. Replace as required.
PADS
 Check for excessive wear. Replace as required.
 Check for excessive pressure on the spout. Adjust as required.