CBE 230 - Page 45

230 Series Auger Packer
45 OF 115
BAG CHAIR ASSEMBLY
PIVOTS
 Check for excessive wear. Grease or replace as required.
SETTLER
 Check for excessive vibration. Check to see if rubber isolator rubber.
PNEUMATIC
FILTERS
 Check for dirty filter elements. Clean or replace as required.
 Check for moisture accumulation. Drain as required.
REGULATORS
 Check regulators for proper pressure setting. Adjust as required.
LUBRICATORS
 Check lubricator oil level. Fill as required.
 Check lubricator flow rate. Adjust as required.
CYLINDERS
 Check the piston rod end seals for deterioration/cracking. Replace as required.
 Check the piston rod for excessive wear. Replace as required.
 Check rod end cushions for smooth operation. Adjust as required.
 Check for loose or missing mounting hardware. Tighten or replace as required.
HOSES
 Check all hoses for deterioration and/or cracking. Replace as required.
 Check for leaks around fittings, valves, seals, etc. Tighten or seal as required.
ELECTRICAL
PHOTO EYES
 Clean all photo eyes and reflectors.
 Check alignment of photo eyes and reflectors. Adjust as required
LIMIT SWITCHES
 Check alignment of limit switches and actuators. Adjust as required.
PROXIMITY SWITCHES
 Check alignment of proximity switches and actuators. Adjust as required.
JUNCTION BOXES
 Check for loose/broken wires or components. Tighten or replace as required.
 Blow off any excessive build-up of product/dust.
 Make sure all J-Boxes are closed when not being worked on.
Control Panels