EasyManuals Logo

CBE PC210-ST User Manual

CBE PC210-ST
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
EN
17
FUNCTIONS
CAR BATTERY ALARM (B1)
Battery Discharge alarm goes on and the symbol
ref. 3 starts blinking. Alarm goes off when the
voltage gets over 12.5V.
LEISURE BATTERY ALARM (B2)
When leisure battery voltage gets 11.5V the Leisure
Battery Reserve alarm goes automatically on, the
symbol ref. 4 starts blinking and you hear a short
beep.
When the leisure battery voltage gets 10.5V, the
Leisure Battery Discharge alarm goes automatically
on, the symbol ref. 4 starts blinking and you hear
two short beeps. Alarms go off when the voltage
gets over 12.5V.
When car battery voltage gets under 12V, car
Symbol ref. 12 is the visual alarm signal.
It is possible to reactivate all users for one minute
by pressing the on/off button (ref. on control
panel)
1
.
graphically by the level guage ref. 2.
The electronic battery protection device cuts off the
12V users when leisure battery reaches 10V and
disables: pump, lights, , and stove.awning light
MINIMUM VOLTAGE CONTROL (BATTERY
PROTECTION)
This device doesn’t control the functions: fridge,
step and the auxiliary exit (direct B2)
Users are automatically reactivated when voltage is
bigger than 13.5V.
TANKS
a) Fresh water tank with electronic probe: levels are
The control panel automatically turns off with a
voltage lower than 9.5V.
displayed numerically in % (steps of 10%) and
b) Waste water tank with screw probe.
FRESH WATER TANK REFILLING
To activate this function press the “test tank” button
ref.3 for more than 4 seconds, until the “water
refilling” is displayed on the screen.
T freshhis function is used during the water refilling
and indicates the water level during refilling.
The control panel beeps in order to warn that tank
- are measured by Both int. and ext. temperatures
Alarm is shown acoustically (when engine is off)
and visually with the symbol ref. .10 blinking
A freshlarm turns on when water level is lower than
1 % of the tank capacity and automatically turns off
when level exceeds 20%.
0
Alarm turns on when the waste water level exceeds
the screw sensor level.
T 2 3o exit this function press buttons ref. or .
FRESH WATER TANK ALARM
WASTE WATER TANK ALARM
Alarm is shown acoustically (when engine is off)
and visually with the symbol ref. 11 blinking.
AWNING LIGHT AUTOMATIC TURN OFF
An electronic device switches off the awning light
when engine is turned on.
is getting filled: one short beep at 75%, two short
beep at 85% and a long beep at 95%.
TEMPERATURE
s andsensor placed inside outside of the vehicle.
- The precision of the temperature value is ± 1°C.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CBE PC210-ST and is the answer not in the manual?

CBE PC210-ST Specifications

General IconGeneral
BrandCBE
ModelPC210-ST
CategoryControl Panel
LanguageEnglish

Related product manuals