EasyManua.ls Logo

CCV Edge IM15 - SAM and SIM Card Slots; Display Specifications

CCV Edge IM15
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Manual - CCV Edge/Frame IM15
14/30
© 2024, CCV GmbH. All rights reserved. No parts of this publication may be reproduced, stored in a retrieval system, or
transmitted in any form by any means, electronic, mechanical, photocopying, recording or otherwise, without the written
permission of CCV GmbH.
4.7 SAM/SIM slots
CAUTION: Always remove the power source of the device before opening the rear cover.
The CCV Edge/Frame IM15 comes with 2 micro-SAM-card slots
(Secure Access Module) for secure payment transactions. To
access these slots, the rear cover (and 4G module in case of LTE
variant) needs to be removed.
To install a SAM-card, open the card-slot and insert the card into
the slot with the clipped corner of the card to the upper right,
then lock the mount with the card inside.
For variants with built-in 4G module, one SIM-card (Micro SIM 3FF) can be installed in the 4G module (board
located underneath the rear-cover). After removal of the rear-cover, you can immediately access this slot.
Unlock the card slot by sliding the clip down and insert the card into the slot with the SIM-card contacts
facing towards the 4G module and with the clipped corner of the SIM-card to the left.
To reassemble the device, mount the back-cover and tighten the screw.
Note: Use SIM cards suitable for the required data volume. The device connects to the Network Service
Provider (transactions) and CCV’s Terminal Management System (software updates). Data usage depends on
the environment where the product is installed. Typical data package sizes are:
Software updates: up to 25 MB
Transactions: estimated up to 2MB per month depending on volume
Heart beats (assuming a daily heart beat): +/- 5 MB per month.
4.8 Display
The display is a 3.5” TFT LCD 480 x 320 pixel touch screen.

Related product manuals