© 2024, CCV GmbH. All rights reserved. No parts of this publication may be reproduced, stored in a retrieval system, or
transmitted in any form by any means, electronic, mechanical, photocopying, recording or otherwise, without the written
permission of CCV GmbH.
1. Before you begin
Before you begin with the installation of the product, make sure the following conditions an requirements are
evaluated thoroughly.
1.1 Installation preparations
Install the payment device in a location/position so that the end-user can safely enter a secure PIN-code
while blocking external views with hand or body. Also take the following conditions into consideration:
• Position the terminal between 80 cm and 120 cm from the ground. Only deviate from this specification
if secure entry of the PIN is not possible.
• PIN-entry cannot be visible from a nearby elevated surface, through mirrors or cameras or any other
way.
• The product has a virtual PIN-pad, which means the touch-screen is used for PIN-entry and other
interactions. Take this into account in the positioning of the product.
• If necessary, an additional privacy shield may be required to provide secure PIN-entry.
• Make sure the product is installed following the environmental conditions specified. See Technical
Specifications of the product for the allowed temperature and humidity conditions.
• Avoid installation where the product is subject to shocks and vibration, direct sunlight, dust, water or
condensation or excessive electromagnetic interference.
To Next Page
Loading...
