© 2024, CCV GmbH. All rights reserved. No parts of this publication may be reproduced, stored in a retrieval system, or
transmitted in any form by any means, electronic, mechanical, photocopying, recording or otherwise, without the written
permission of CCV GmbH.
- The device contains tamper-proofing features. These circuits will trigger if the device is disassembled or
subjected to heavy shock, at which point it will have to be rearmed by CCV before the device is ready to
resume normal operation.
- In case of malfunctions, check the integrity of the device. Check if the product shows visual damage or
manipulation. In case of damage, tampering or a broken seal, do not operate the product and immediately
contact your payment provider or CCV for assistance.
9.2 Environmental information and decommissioning
9.2.1 Disposal information
Waste Electrical and Electronic Equipment (WEEE)
The symbol indicates that, under the European Directive 2012/19/EU governing waste from
electrical and electronic equipment, the product should not be discarded as unsorted waste but
must be sent to separate collection facilities for recovery and recycling. The WEEE marking must
appear on any electrical and electronic equipment placed on the EU market.
When the product is no needed or has become obsolete/unusable, it can be decommissioned in an
environmentally friendly manner and appropriate security measures must be taken prior to re-
purposing/disposal (i.e., removal/decommissioning of SAM/SIM cards inside the product).
9.2.2 RoHS
Directive 2011/65/EC (RoHS 2) on the restriction of certain hazardous substances in electrical and electronic
equipment. RoHS 2 compliance is indicated by the CE marking on the product.
According to the information declared by our component suppliers, this product is RoHS compliant.
9.3 Cleaning instructions
The product is designed for outdoor use, but it is strongly recommended to install the product with
protection for dirt and possible liquids contaminants, and at regular intervals clean the product. Dust and
liquids may result in fire.
The product uses a lens for reading barcodes. It is advised to clean this lens at regular intervals to maintain a
good reading performance.
If applicable, card-readers (internal or external) should be cleaned at regular intervals, depending on the
usage and environmental conditions. This can be done by using standard dry cleaning cards and the device
does not need dismantling for this process. The following recommendation applies for cleaning intervals of
card-readers:
To Next Page
Loading...
