© 2024, CCV GmbH. All rights reserved. No parts of this publication may be reproduced, stored in a retrieval system, or
transmitted in any form by any means, electronic, mechanical, photocopying, recording or otherwise, without the written
permission of CCV GmbH.
7. Configuration
This section describes the initial setup of the device and configuration of the device parameters:
7.1 Initial device setup
When the device is first started, an automatic setup procedure will start and the following settings can be
configured:
7.1.1 Orientation
The product can be used in both landscape and portrait orientation. This setting can be changed again after
the initial setup. The choice of orientation can have an impact on how content is shown on the screen so
please align with your integration team on what the best orientation is for your use case.
7.1.2 Language
Select one of the available languages on the screen. The list of languages consists of multiple pages. Use the
soft-buttons to scroll to the next/previous page if you don’t see your language on the screen.
7.1.3 Terminal ID
This is a unique identifier for this specific terminal which is provided by CCV. It defines how a terminal
behaves and makes sure transactions can be linked to a specific device. If you don’t know your terminal ID,
please reach out to CCV support.
7.1.4 Connectivity
Here you can choose how the terminal will connect to the payment backend. The terminal always needs to
be connected, so please make sure you use a stable connection. Ethernet is the preferred connectivity
method for stability.
7.1.5 DHCP
Dynamic Host Communication Protocol makes sure that the terminal automatically gets an IP address
assigned to. If, for some reason, you need to use a static IP address, select no on this screen. To get an IP
address assigned automatically, the Terminal must be connected to a router with an active DHCP server.
7.1.6 ECR connection
In this menu, the protocol for communication can be selected. Please make sure to align with your
integration team on which protocol to choose in this screen. Once the protocol is selected, you will also need
to enter the server and port to which the connection must be made.
To Next Page
Loading...
