33
cdvigroup.com
A22K
High Security Access Control 2-Door Module
Here are the steps to reset the A22K to the factory default settings:
• Press & hold the “MODE” button for ten “STAT” LED ash sequences (+/- 10 seconds),
then release the “MODE” button.
• Approximately 2-3 seconds later, the “STAT” LED will blink twice
• Immediately press and hold the “MODE” button until the “STAT” LED blinks rapidly (+/- 5 seconds),
then release the “MODE” button
• The controller will reboot and will be restored to factory default settings (+/- 30 seconds)
“STAT” LED & “MODE” button
Events won’t be deleted on a reset factory default of the A22K controller
To Next Page
Loading...
