EasyManua.ls Logo

Cedima CTS-81 - User Manual

Cedima CTS-81
32 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Operating Manual 70 9998 0329 / UK 003
Bench Saw CTS•81, L, XL
Operating Manual and Safety instructions

Table of Contents

Questions and Answers

  • J
    joe98Aug 11, 2025
    What to do if my Cedima Saw blade drive motor switches off automatically?
    • L
      Lauren HarrisAug 12, 2025
      If your Cedima Saw blade drive motor switches off automatically, it could be due to several reasons. First, check if the cutting pressure is too high and reduce it if necessary. Another possibility is that the wrong saw blade type is installed; make sure to install the correct saw blade. Finally, a defect in the electrical installation could be the cause, in which case you should have the saw inspected and repaired by a qualified electrician.
  • A
    Andrew PotterAug 20, 2025
    Why Cedima Saw won’t start after pushing the ON button?
    • T
      Tyler RodriguezAug 20, 2025
      If your Cedima Saw won’t start after pushing the ON button, there are several potential causes. Ensure the mains cable is properly connected. If the cable is defective, have it replaced by a qualified electrician. The mains switch could also be defective, requiring replacement by a qualified electrician. Internal wiring issues or a defective blade drive motor could also be the problem; in either case, have the saw inspected and repaired or the motor replaced by a qualified electrician.
  • M
    Mary JohnsonAug 27, 2025
    How to troubleshoot insufficient power in Cedima Saw blade drive motor?
    • N
      nicolemarshAug 27, 2025
      If the blade drive motor of your Cedima Saw provides insufficient power, it might be due to a power loss from an excessively long mains cable; try using a shorter cable. Another cause could be a wound-up cable drum; unwind the cable. If neither of these resolves the issue, the blade drive motor may be defective and should be replaced by a qualified electrician.
  • C
    charlesleachSep 3, 2025
    What to do if there is insufficient cooling water supply in Cedima Saw?
    • W
      William SanchezSep 4, 2025
      If you're experiencing an insufficient or missing cooling water supply in your Cedima Saw, first verify that the wet-pit pump is fully submerged in the water. If the pump is submerged, check if the filtering screen is clogged and clean it if necessary. Also, the pump impeller might be dirty; open the wet-pit pump and clean the impeller. If problems persist, the wet-pit pump itself may be defective and should be replaced by a qualified electrician.

Cedima CTS-81 Specifications

General IconGeneral
BrandCedima
ModelCTS-81
CategorySaw
LanguageEnglish