Sect. 2 - Basic Safety Instructions
•
CEDIMA
®
• Technical Documentation • All rights reserved as per DIN 34 • „Subject to modifications due to progressive development“ •
Page 11
Bench Saw CTS•81, L, XL
Operating Manual 70 9998 0329 / UK 003
nal features, such as job organization, work
flows or the personnel entrusted with the work.
• Personnel entrusted with work on the machine
must have read the operating manual prior to
taking up work. This applies especially to per-
sons working only occasionally on the machi-
ne, e.g. during set-up or maintenance activities.
• Check - at least from time to time - whether the
personnel is carrying out the work in com-
pliance with the operating manual and paying
attention to risks and safety-relevant factors.
• For reasons of safety, long hair must be tied
back or otherwise secured, garments must be
close-fitting and no jewellery - including rings -
may be worn. Severe injury may result from
being caught by moving parts of the machine.
• Personal protective equipment must be used
wherever required by the circumstances or by
law (e.g. safety glasses, ear protectors, safety
boots, suitable safety clothing). Observe the re-
gulations for the prevention of accidents!
• Observe all safety precautions and warnings at-
tached to the machine and always keep them in
good and perfectly legible condition.
• In the event of safety-relevant modifications or
changes in the behaviour of the machine, stop
the machine immediately and report the mal-
function to the competent authority/person.
• Do not remove or make inoperative any safety
devices the machine is equipped with.
• Never make any modifications, additions or
conversions which might affect safety without
the manufacturer’s/distributor’s prior consent!
This also applies to the installation and adjust-
ment of safety devices as well as to welding
and drilling work on supporting structures.
• Damaged or worn parts of the machine must be
replaced immediately. Use genuine spare parts
only.
• All spare parts and tools must comply with the
technical requirements specified by the manu-
facturer/distributor.
• Adhere to the legally prescribed preventive
maintenance and inspection intervals or those
specified in this operating manual!
• All maintenance and repair activities must be
performed by qualified personnel using suitable
tools and other suitable workshop equipment.
2.4 Selection and qualification of
personnel
• Any work on and with the machine must be
executed by reliable personnel only. Statutory
minimum age limits must be observed!
• The machine must be operated or serviced by
trained or properly instructed personnel only.
Clearly define the individual responsibilities of
the personnel for operation, set-up, mainte-
nance and repair.
• Make sure that only authorized personnel work
on or with the machine.
• Do not allow persons to be trained or instructed
or persons taking part in a general training
course to work on or with the machine without
being permanently supervised by an experi-
enced person.
• Work on the electrical system and equipment of
the machine must be carried out only by a skil-
led electrician or by properly instructed persons
working under the supervision and guidance of
a skilled electrician and in accordance with
electrical engineering rules and regulations.
2.5 Normal operation of the machine
• Before you start working, make yourself fami-
liar with the surroundings and circumstances of
the site, such as obstacles which might impede
work, the soil bearing capacity and the required
safety measures, e.g. barriers separating the
work site from public traffic.
• Never use the machine in a way that might be
contrary to safe working practices!
• Make sure that the machine is used only when
it is in a safe and reliable condition. Operate the
To Next Page