Page 14 •
CEDIMA
®
• Technical Documentation • All rights reserved as per DIN 34 • „Subject to modifications due to progressive development“ •
Sect. 2 - Basic Safety Instructions
Bench Saw CTS•81, L, XL
Operating Manual 70 9998 0329 / UK 003
ferred to as fluids or lubricants), follow the
safety instructions that are relevant to the resp-
ective product!
• Avoid any prolonged contact between fluids or
lubricants and your skin. Carefully clean your
skin to remove all fluids or lubricants adhering
to it.
• Be careful when handling hot fluids or lubri-
cants. Risk of serious injuries or burns! Especi-
ally when handling fluids or lubricants with
temperatures exceeding 60 °C make sure to
avoid any contact between the fluid and your
skin!
• If fluids or lubricants have come into contact
with your eyes, rinse your eyes immediately
and thoroughly with clean drinking water and
consult a doctor.
• Spilled fluids or lubricants must be removed
immediately using binding agents.
• Fluids or lubricants must not penetrate into the
soil or public sewage system.
• Used fluids or lubricants must be collected,
stored and disposed of properly.
• Follow all relevant legal instructions and provi-
sions regarding the handling and disposal of
fluids or lubricants. In case of doubt, contact
the competent authorities for detailed informa-
tion.
2.9 Transporting the machine
• It is not allowed to transport the machine using
a lifting gear.
• Before relocating the machine, make sure that
the mains plug is unplugged and all movable
parts are locked mechanically.
• Always disconnect the machine from the mains
supply even when performing minor relocati-
ons!
• Use only load suspension devices with suf-
ficient load capacity while performing loading/
unloading operations!
• Use only suitable transport vehicles with suf-
ficient load capacity!
• Secure the load carefully. Use suitable faste-
ning points for securing it!
• Parts which had to be removed for transporting
the machine must be refitted and secured care-
fully before the machine is used again!
• The recommissioning procedure must be strict-
ly in accordance with the operating manual!
Observe the instructions given in the operating
manual when reassembling and operating the
machine.
To Next Page
Loading...