Page 24 •
CEDIMA
®
• Technical Documentation • All rights reserved as per DIN 34 • „Subject to modifications due to progressive development“ •
Sect. 5 - Care and maintenance
Bench Saw CTS•81, L, XL
Operating Manual 70 9998 0329 / UK 003
5. Care and maintenance
The general safety instructions included in this
operating manual (see sect. 2) must be followed
while performing maintenance and care activi-
ties. In addition to that, observe the following
provisions:
Attention:
Unplug the mains plug!
Unplug the mains plug before you perform
any maintenance or cleaning activities!
Attention: Do not use any aggressive cle-
aning agents!
Do not use aggressive cleaning fluids (e.g. sol-
vents), and do not clean the machine using li-
quids with a temperature exceeding 30 °C.
Attention:
Do not use high-pressure cleaners!
For safety and functional reasons, make sure that
no water, steam, or cleaning agents are allowed
to penetrate into electrical components (e.g. mo-
tors, switches, plug connections, etc.) or bea-
rings. The use of high-pressure cleaners for cle-
aning the saw is therefore not admissible.
Attention:
Do not grease the guide rail!
Do not apply grease or other lubricants to the
guide rail! This would cause the buildup of dirt
on the guide rail and could result in damage to
the bearings!
5.1 Dry cleaning
• Use a slightly damp cloth to remove dust and
dirt particles from the machine.
• Use only lint-free cleaning cloths.
• Remove any hardened buildup of dirt using a
brush.
5.2 Wet cleaning
• Prior to wet-cleaning the Bench Saw, cover all
plug connectors with suitable protective caps in
order to prevent the ingress of humidity.
• If necessary, remove dirt and other residues
using a brush and a low-pressure water jet.
• After cleaning the Bench Saw with water, con-
nect the machine to a mains supply that is pro-
tected by an FI fault current breaker. If the FI
fault current breaker is tripped, the Bench Saw
must not be restarted until after a thorough in-
spection by a qualified electrician.
5.3 Regular cleaning and maintenance
activities
The Bench Saw must be cleaned after each use
and before performing any maintenance/repair
activities. Clean the machine as follows:
• Remove the work table before you clean the
water trough. The work table only hangs in the
frame (fig. 5.1) and can be taken out easily.
Fig. 5.1 Seat of the work table
• Remove the contaminated water and any buil-
dup of mud from the bucket and water trough.
• Clean the filtering screen of the wet-pit pump.
Flush the pump with clean water in order to
prevent the pump from blocking due to harde-
ned accumulations of mud. (For more informa-
To Next Page
Loading...