Page 12 •
CEDIMA
®
• Technical Documentation • All rights reserved as per DIN 34 • „Subject to modifications due to progressive development“ •
Sect. 2 - Basic Safety Instructions
Bench Saw CTS•81, L, XL
Operating Manual 70 9998 0329 / UK 003
machine only if all protective and safety-orien-
ted devices (e.g. guards, emergency shut-off
equipment, etc.) are in place and fully operati-
ve.
• Each time before you start working, check the
machine for obvious damage and defects. Any
changes (including changes in the performance
or behaviour of the machine) must be reported
to the competent authority/person immediately.
• In the event of malfunctions or changes in the
machine’s behaviour, stop the machine imme-
diately and secure it against restarting. Have
any defects rectified immediately!
• Before you start performing cutting operations,
check that the diamond saw blade is
- in proper condition and
- securely attached.
• The cutting operation must be performed using
the wet cutting method in order to prevent the
formation of hazardous clouds of fine dust and
to improve the service life of the cutting tool.
• Follow the startup and shutdown instructions
given in the operating manual.
• Before you start up the machine or set it to mo-
tion, make sure that the starting or running ma-
chine does not create any hazard to other per-
sons’ health.
• Hearing protectors must be used throughout the
cutting operation.
• The machine is designed for use in daylight en-
vironments. When working in unlighted areas
the user/operator must ensure a sufficient illu-
mination of the site.
• Before leaving the machine always secure it
against inadvertent movement and unauthori-
zed use!
2.6 Special work related to the mainte-
nance and repair of the machine
• Observe the adjustment, maintenance and in-
spection activities and intervals set out in the
operating manual, including information on the
replacement of parts or assemblies! These acti-
vities may be performed by skilled personnel
only.
• Brief the operating personnel before initiating
special repair or maintenance activities. Ap-
point a person to supervise such activities.
• In any work concerning the operation, adaptati-
on to production requirements, conversion or
adjustment of the machine and its safety-orien-
ted devices or any work related to inspection,
maintenance and repair, always observe the
start-up and shut-down procedures described in
the operating manual as well as the instructions
on maintenance activities!
• Maintenance and repair work may be carried
out only if the machine is placed on level and
solid ground and secured against inadvertent
movement.
• If the machine is completely shut down for
maintenance or repair work, it must be secured
against inadvertent restarting.
• When using a lifting gear for replacing indivi-
dual parts or large assemblies make sure that
the parts/assemblies are carefully attached to
the lifting gear and secured in place to avoid
hazardous conditions. Use only suitable and
technically perfect lifting gear and suspension
systems with adequate lifting capacity! Never
work or stand under suspended loads!
• The fastening of loads and the instructing of
crane/industrial truck operators should be ent-
rusted to experienced persons only! The in-
structor must be within sight or sound of the
operator. Use an intercom system if necessary.
• Before performing any maintenance/repair acti-
vities clean the machine, especially the connec-
tors and screwed joints, and remove any oil,
dirt and preservative agents. Never use aggres-
sive detergents! Use lint-free cleaning rags!
• Before cleaning the machine with water or
other cleaning agents cover or tape up all ope-
nings which -for safety and functional reasons-
must be protected against the ingress of water/
To Next Page
Loading...