Page 30 •
CEDIMA
®
• Technical Documentation • All rights reserved as per DIN 34 • „Subject to modifications due to progressive development“ •
Sect. 8 - Terms of Warranty
Bench Saw CTS•81, L, XL
Operating Manual 70 9998 0329 / UK 003
other assistants are borne by the buyer. The
warranty expires, if the customer or any
other, unauthorized person, interfere with the
purchased device.
7. If the replacement of assemblies or compon-
ents by the buyer or others has been expres-
sly arranged with us, any possible recogniti-
on of the warranty case cannot be given by us
until after the defective parts have been retur-
ned to us and inspected by us.
8. According to the statutory regulations the
buyer is only entitled to cancel a contract, if
we refuse improvements or the supply of re-
placements acc. to fig. 4 even though a defect
has been proven, or a deadline that we have
been given has elapsed unfulfilled. If only a
minor defect has occurred, the buyer is
merely entitled to an abatement of the
purchase price, wich in any other case is ex
-
cluded. We are not liable for compensation
on account of a defect or damages subse-
quent to a defect, unless these occur on ac-
count of an intention or a negligence which
we are responsible for.
9. No guarantee is assumed for damages that
have arisen of the following reasons:
a) faulty installation,
b) improper use or overstressing,
c) permanent overload, leading to damages
to coils or the windings of armatures,
d) extraneous causes, e.g. transport damages,
climatic influences or other natural pheno-
mena,
e) use of integral or accessory parts that are
not suitable/adjusted to our devices.
10. If there is reason for complaint about a dia-
mond tool(s), this tool(s) must be removed
from the machine immediately! To protect
your interest and to conduct a proper inspec
-
tion, a segment height of at least 20 % (of
height in new condition) is required. Failure
to observe this will lead to any claims to re-
placement that you may have being voided!
11. If warranty claims are satisfied by us, then
this neither extends the warranty period nor
does it begin a new warranty period for the
device. The warranty period for installed
spare parts shall end no sooner or later than
the warranty period for the device.
12. Otherwise, our complete terms of sale and
delivery apply.
13. The place of performance and venue for both
parties is Celle.
CEDIMA
®
Diamantwerkzeug- und
Maschinenbaugesellschaft mbH,
Celle, Germany
January 2005
Page 2 of 2 Pages
To Next Page
Loading...