CEM SMART System 5 - Page 59

52
Moisture/Solids Analysis
1. STANDARD TEST
2. WASTEWATER
3. DILUTION
4. SYRINGE WEIGH
5. ASH
Press item number to select.
.
MAIN PREV
MENU PAGE
WasteWater
1. POWER: 0 %
2. DELTA WEIGHT: 0.0 mg
3. DELTA TIME: 0 secs
4. MAX TIME: 10 mins
5. BIAS: ±0.00 %
6. MAX TEMP: 110 C
Press item number to select
or NEXT PAGE for more menu items.
MAIN PREV NEXT
MENU PAGE PAGE
10. Press “2” to select “Wastewater.”
11. Press the numbers (1 - 6 Constant Weight
or 1 - 4 Set Time) and enter the appropriate
method parameters.
Note: Refer to the QUICK TEST section of this
manual for instructions for entering method
parameters for Constant Weight and Set Time.
12. Press the operation key below NEXT
PAGE to access additional method
parameters.
13. Press “1” to toggle and select “TSS.”
14. Press the numbers (2 - 8) and enter the
appropriate method parameters.
15. Press READY to begin the method
analysis.
WasteWater
1. POWER: 0 %
2. RUN TIME: 00:00 min:sec
3. BIAS: ±0.00 %
4. MAX TEMP: 110 C
Press item number to select
or NEXT PAGE for more menu items.
MAIN PREV NEXT
MENU PAGE PAGE
C
O
N
S
T
A
N
T
W
E
I
G
H
T
S
E
T
T
I
M
E
WasteWater
1. OPTION: TSS
2. VOLUME: XXX ml
3. RESULT RANGE: MOISTURE
4. MIN RESULT: X.XX%
5. MAX RESULT: XX.XX%
6. MIN WT RANGE: X.XX g
7. MAX WT RANGE: X.XX g
8. WT COMPENSATION: OFF
Press READY to run test.
MAIN PREV
MENU PAGE