8
ENGLISH
Use and maintenance manual
Starting
3. Starting
Before switching on the machine, make sure that all the connections described in the INSTALLATION chapter
have been made correctly.
The following operations involve a potential risk for the operator, given the presence of voltage on the equipment.
The Personal Protective Equipment described in the INSTALLATION manual must be worn and work must be done with due care and
attention. Operations may only be performed by a specialised technician.
Before powering the machine, carry out the following checks:
1. Check that the balancing machine touches the floor at the three support points.
2. Make sure that all the parts of the balancer are correctly connected and fixed.
3. Make sure that the parameters (voltage and frequency)
of the mains power supply are compatible with
those indicated on the rating plate of the balancer.
4. Make sure the power cable is correctly connected.
5. Make sure the machine shaft and flange hole are clean.
Any traces of dirt may affect balancing accuracy.
6.
To turn on the wheel balancer press the switch on the side or back of the same; for the models with
touchscreen don’t touch the screen.
Press the buttons with your fingers. Never use the counterweight grippers or other pointed objects!
To Next Page
Loading...
Need help?
General
