CENTURION SYSTEMS D20 SMART - Page 4

page 4 www.centsys.com
7.8. Height Adjustment
7.9. Mounting the Rack
7.9.1. Fitting Steel Rack to the Gate
7.9.2. Finalising the Height Adjustment
7.9.3. Placing the Gearbox Mounting Washers, Spring Washers and Lock Nuts
7.10. Re-assembling the Operator
7.10.1. Placing the Gearbox Trim and Charger back into Position
7.10.2. Placing the Control Card back into Position
7.10.3. Reconnecting the Harnesses to the Control Card and Charger
7.11. Installing the Origin Sensor and Marker
7.11.1. Installing the Origin Sensor
7.11.2. Mounting the Origin Marker
7.11.3. Mounting the Origin Marker onto the Steel Rack
8. COMPLETING THE INSTALLATION
8.1. Fitting the Batteries
8.2. Accessory Installation and Storage
8.3. Wiring the Control Card on its Default Settings
8.3.1. Closing Infrared Beam Wiring (i5 Infrared Beams)
8.3.2. Closing Infrared Beam Wiring (Photon Infrared Beams)
8.3.3. External Radio Receiver and Loop Detector Wiring
8.3.4. G-ULTRA to D10 SMART / D10 Turbo SMART / D20 SMART Wiring
8.4. Commissioning the System
8.5. Apply Warning Decal
9. GENERAL MAINTENANCE
9.1. Gate Maintenance
9.2. D10 SMART / D10 Turbo SMART / D20 SMART Maintenance
10. INSTALLATION HANDOVER
11. WARRANTY INFORMATION
Page 33
Page 34
Page 35
Page 35
Page 37
Page 37
Page 37
Page 38
Page 39
Page 40
Page 40
Page 41
Page 42
Page 43
Page 43
Page 44
Page 45
Page 45
Page 46
Page 47
Page 48
Page 48
Page 49
Page 50
Page 50
Page 51
Page 52
Page 53
CONTENTS
Icons used in this manual
This icon indicates tips and other information that could be useful during the
installation.
This icon denotes variations and other aspects that should be considered during
installation.
This icon indicates warning, caution or attention! Please take special
note of critical aspects that MUST be adhered to in order to prevent
injury.