CH A1 - 4.3.1.2 DISPLAY SETTINGS

Mono passive bi-amp
Bridge
Monaural 1
Monaural 2
None
None
None
None
GAIN 24 dB range by 0.5 dB
steps
Stereo or bridged mode None
GAIN 1 /
GAIN 2
24 dB range by 0.5 dB
steps
Bi-amp mode In passive bi-amp mode, channels 1 and 2 can only
have a gain difference of up to 6 dB
INPUT BOARD Left, Right 2 input boards + passive
bi-amp or bridged mode
Details of AUDIO SETTINGS menu Parameters
4.3.1.2 DISPLAY SETTINGS
The A1 SETUP >> DISPLAY SETTINGS menu allows configuration of the display
related Parameters of the unit. Accessible Parameters are:
- DISPLAY MODE:
- LED ON/OFF:
- BRIGHTNESS NORMAL:
- BRIGHTNESS DIMMED:
- COLOR:
- GAMMA:
Selects what is displayed in normal mode
Selects if the LED is turned on
Sets the normal display brightness
Sets the dimmed display brightness
Selects the display color
Fine tunes the AMOLED's display RGB gamma curve
The following table details the Parameters of the DISPLAY SETTINGS menu:
PARAMETER PARAMETER VALUES REQUIRED OPTIONS REMARKS
DISPLAY MODE Status
Power
Temperature
Off
None Selects what to display when the unit is idle for several
seconds: General status page, power-meter, temperature
gauges or turn off the display.
LED ON/OFF On
Off
None Allows to keep the LED on when the unit is on.
BRIGHTNESS NORMAL 10%
20%
30%
...
90%
100%
None Sets the display brightness when the unit is operated.
Rev 2.0 A1 User Manual 33