3 Installation
3.1 Unpacking
Unpack the C1 D/A controller and store the packaging for future transportation. Be careful when lifting the C1 as the unit is heavy
(over 20kg). Get someone to help you if necessary. When unpacking and installing the C1, take care not to damage the high
quality surface treatments.
3.1.1 Removing the security screw
The transformer base plate must be secured during transportation to avoid damage to the isolating silent blocks. The security screw
is located at the bottom of the unit. To remove the security screw, tilt the unit on its side and unscrew. Do not tilt the unit on the
front or back panels as this may damage the user control knob or the connectors.
Security screw location
(1) Security screw. Must be mounted for transport and removed at installation
3.2 Positioning
Position the C1 unit on a stable base. Make sure cooling air is able to freely flow around the unit.
3.2.1 Unit position adjustment
The C1 D/A controller is equipped with height adjustable feet. More precisely, each feet has an internal height adjustable spike
which can be accessed with the provided adjustment screwdriver through the adjustment shafts. When delivered from factory, the
adjustment spikes are not mounted in the feet but are located in the accessory box. Remove the adjustment spikes from the
accessory box and put one into each adjustment shaft. Place the provided screwdriver into the adjustment shafts and turn clockwise
to secure the spikes and make the required adjustments.
Rev 1.9 C1 User Manual 17
To Next Page
Loading...