CH C1 - C1 Configuration Menu Items; Audio Setting

There are six main menus used for configuration of the C1:
• AUDIO SETTING: Allows to adjust audio related parameters
• DISPLAY SETTING: Allows to adjust display related parameters
• SHORTCUTS: Allows to assign and modify Shortcuts for user interface customization
• FACTORY SETTING: Indicates the software version and allows to update it. Also allows to return to factory settings and
calibrate the C1
• INSTALLED OPTIONS: Provides information about the installed optional slot-in boards
• NETWORK: Provides information about the network setup and enables its configuration
4.3.1 C1 configuration menu items
4.3.1.1 AUDIO SETTING
The C1 SETUP >> AUDIO SETTING menu allows configuration of the audio related
Parameters of the unit. Accessible Parameters are:
- MUTE:
- PHASE POLARITY:
- CLOCK SOURCE:
- INPUT TYPE:
- INPUT GAIN:
- BALANCE:
- MONO MODE:
- PCM FILTER TYPE:
- DSD FILTER TYPE:
- C1 TYPE:
- MAX START VOL:
- MAX VOLUME:
- USB AUDIO CLASS:
- USB AUDIO POWER:
- PHONO CURVE:
Mutes or unmutes the audio output
Allows to revert the phase of the audio output
Allows to select the clock source for each input
Selects if an input is hidden, and/or volume controlled.
Sets individual gain/attenuation per input
+/-6dB L/R balance correction
Allows to route left (resp. right) input to both outputs
Digital filter selection for PCM audio
Digital filter selection for DSD audio
Enables volume control
Sets maximum allowed volume at startup in controller
mode
Sets maximum allowed volume in controller mode
Select class 1.0 (96/24 max) or class 2.0 (192/24 max)
Allows USB audio section power off when unused
Selects correction curve for phono input board
The following table details the Parameters of the AUDIO SETTING menu:
PARAMETER PARAMETER VALUES REQUIRED OPTIONS REMARKS
MUTE Muted None None
Rev 1.9 C1 User Manual 35
C1 SETUP >> AUDIO SETTING
MUTE
PHASE POLARITY
CLOCK SOURCE
INPUT TYPE
...
Unmuted
In phase
...
...